Skip to content

Announcement: Introducing HL8545/G: Quad-Channel 50 mΩ High-Side Switch for Advanced Automotive Applications


The HL7139A is the low voltage fast direct charger for 1 cell Li-ion and Li-polymer batteries. The device integrates a dual-phase switched capacitive converter and reverse blocking MOSFET (QRB FET) and shows 97.4% efficiency for 4.5V output and 5A charging current with 2x22uF per phase.

The switched capacitor converter architecture of this device and the integrated FET are optimized to enable a 50% duty cycle operation under Charge Pump (CP) Mode. The CP mode allows the output voltage VOUT to be around half of the input voltage VIN and the output current to be double of the input current, reducing the losses over the input power cable as well as limiting the temperature rise in the application. The dual-phase architecture reduces the input capacitance requirements as well as reducing the input voltage ripple. Besides CP Mode, the device also has Bypass (BP) Mode. BP Mode allows VIN forwardly passing through internal power FETs to VOUT without any conversion.

The HL7139A provides CC regulation and CV regulation through controlling the QRB FET for a safe charging operation. CC regulation is controlled through a close loop of the input current sensing or battery current sensing and CV regulation is controlled through a close loop of the battery voltage sensing. In addition, HL7139A also supports thermal regulation loop in case CV/CC loop causing device over-heat during regulation operating.

For more detailed description of the device, please download a product brief.



  • High reliable AMR input/output pins
    • 37V AMR on VBUS
    • 22V AMR on VIN pin
    • 7V AMR on VOUT, BATP
  • Built-in external input NFET control
  • Wide range operating voltage
    • 3V to 11.7V Operational VIN voltage
    • 5.5V Max operational output voltage
  • Dual conversion modes
    • 2:1 Charge pump mode (CP mode)
      • Optimized for 50% Duty
    • 1:1 Bypass mode (BP mode)
  • High efficiency charge pump
    • 97.4% Efficiency for VOUT=4.5V_5A with 2x22uF
    • 97.6% Efficiency for VOUT=4.5V_5A with 3x22uF
  • Regulation loop for charging operation through QRB FET control
    • Input current regulation
    • Battery voltage regulation
    • Battery current regulation
    • Thermal regulation
  • Selectable switching frequency from 500kHz to 1.6MHz
  • Spread spectrum to minimize EMI

Block Diagram

HL7139A - HMI Main Photo

For more information or a full datasheet request, please contact the factory at

Related Products

Part Description
HL7132 Dual-Phase 30W Charge Pump (CP) Direct Charger
HL7132D Dual-Phase 30W Charge Pump Charger with 1:2 Reverse Boost Mode
HL7137 Dual-Phase 7.5A 2:1 Direct Charge Pump Charger
HL7138 Dual-Phase 35W Charge Pump Charger
HL7227 Dual-Phase 60W Charge Pump Converter